Sometimes a tab you built in one diagram belongs in another, a reference board, a template flow, or a section you want to carry over. Add to Diagram copies the active tab into another diagram you own, without leaving the editor.
Copying a tab across
The option is only available when you actually have somewhere to copy to: if this is your only diagram, Add to Diagram is greyed out until you create another.
What gets copied
Add to Diagram makes a copy, so the original tab stays exactly where it is. The destination diagram gets the tab's elements and layout as a new tab of its own. From there it is an ordinary tab in that diagram: rename it, fold it into a tab folder, or restyle it without affecting the source.
Building the same starter board again and again? Keep a master copy in one diagram and use Add to Diagram to drop it into each new project, then tailor it from there.
Was this article helpful?